We have our own VID and PID block reserved, so I would like to put it in the code. Since I'm a little slower than the other kids, I could not find where this is. QUESTION: Being brand new to the USB game, I assume the VID and PID are hard-coded somewhere in the example code. Here is what the running program looks like except that I modified the VID/PID and default send data: NOTE - there are code modifications required and defined in the readme. I initially compiled the C# program for "all processors" and it would compile and run, but it would not connect to the device and echo data. Here is the link:įollow the readme instructions EXACTLY and it will work. USB\VID30DE&PID6544\0022CFF653ECC411A350A2F9 USB\VID30DE&PID6544\0022CFF653ECC411A350A2F9 USB Mass Storage Device PS C:\Users\jonathan. This required downloading and modifying code from per the readme.pdf (attached) in the example code folder. Using the SDK for that board including the USB stack and FreeRTOS, I have successfully tested the example code for the generic HID with FreeRTOS ("dev_hid_generic_freertos"). USB flash drives with hardware encryption typically consist of an encrypted storage partition and a second utility partition that contains a utility for unlocking the encrypted partition. I am using the TWR-K22F120M tower board to develop a USB device.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |